The P0401 trouble code is a diagnostic trouble code (DTC) that indicates “Exhaust Gas Recirculation (EGR) Flow Insufficient Detected.” This code is triggered when the engine control module (ECM) detects that the EGR system is not allowing enough exhaust gases to recirculate into the intake manifold. The EGR system plays a crucial role in reducing
The P0068 trouble code is a diagnostic fault code that indicates a discrepancy in the readings from the manifold absolute pressure (MAP) sensor, mass airflow (MAF) sensor, and throttle position sensor (TPS). This code typically arises when the Powertrain Control Module (PCM) detects that the signals from these sensors do not correlate correctly, which can
The Acura Code P0842 is an error code that could indicate a wide range of issues with an Acura vehicle. This code is usually triggered when the input signal from the 2nd clutch transmission fluid pressure switch to the PCM is low when driving in 1st gear, 3rd gear, or 5th gear. The cause of
Ford code P0230:14 is a continuous and on-demand diagnostic trouble code (DTC) set when the Body Control Module (BCM) detects a short to ground or open from the fuel pump relay coil circuit. This code can seriously impact a Ford vehicle’s engine performance and must be addressed as soon as possible. This article will discuss
The task may seem daunting when diagnosing and solving Chevrolet Code B1517 03. This code refers to a battery voltage below the threshold and can be caused by a control module or sensor detecting a system voltage of fewer than 9 volts or greater than 18 volts for over 5 seconds. Diagnosing the cause of
Solution: Inspect the (T752) Starter Relay Control circuit for any shorted to voltage, shorted to ground, open, or high resistance. Repair any shorted to voltage, shorted to ground, loose, or high resistance as required. Chrysler Code P0615 is a common error code for vehicles manufactured by Chrysler. This code signals that the Starter Control Circuit
When it comes to diagnosing and repairing Dodge vehicles, the code P012B is one of the most common codes encountered. This code indicates an issue with the Turbocharger/Supercharger Inlet Pressure Sensor 1 Circuit Performance. This code is often associated with a 5-Volt Supply Circuit Open, excessive resistance in the Supercharger Inlet Map Signal Circuit, excessive
Drivers of Ford cars may come across the dreaded Ford Code P1405, which can be troublesome to diagnose and repair. This code is associated with the DPFE (Delta Pressure Feedback EGR) Sensor. It is triggered when the PCM (Powertrain Control Module) detects an EGR flow in a negative direction, which typically means that the EGR
Ford Code P2800 is a trouble code used to indicate an issue with the transmission range sensor of a Ford vehicle. When the powertrain control module (PCM) detects an inconsistency between the two voltage signals from the transmission range (TR) sensor, it will activate the Ford Code P2800. This code will cause the transmission to
Ford code P013A is a code relating to a fault in the oxygen sensor in Ford vehicles. This code is specific to the response rate of the rear heated oxygen sensor (HO2S) to a rich to lean transition. When the measured response rate is slower than the threshold value, this code is displayed. To identify
